6
43
THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY. IF USED
COMMERICALLY WARRANTY IS VOID.
IMPORTANT SAFETY INSTRUCTIONS
When using an appliance, basic precautions should always be followed,
including the following:
•
WARNING: READ AND UNDERSTAND ALL INSTRUCTIONS. FAILURE TO
FOLLOW ALL INSTRUCTIONS LISTED BELOW MAY RESULT IN ELECTRIC
SHOCK, FIRE, AND/OR SERIOUS PERSONAL INJURY.
• WARNING: WHEN USING THIS PRODUCT BASIC PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
• READ ALL INSTRUCTIONS BEFORE USING THIS PRODUCT
•
To reduce the risk of injury
, close supervision is necessary when a product is
used near children.
•
Be thoroughly familiar with controls.
Know how to stop the product and
release pressure quickly.
•
Stay alert and exercise control.
Watch what you are doing and use common
sense. Do not operate product when you are tired. Do not rush.
•
Do not operate the product while under the influence of drugs, alcohol, or
any medication.
•
Keep the area of operation clear of all persons
, particularly small children,
and pets.
•
Don’t overreach or stand on unstable support.
Keep proper footing and bal-
ance at all times.
•
Follow the maintenance instructions specified in this manual.
•
This product is provided with a ground fault circuit interrupter built into
the power cord plug.
If replacement of the plug or cord is needed, use only
identical replacement parts.
•
WARNING: Risk of injection or injury
– Do not direct discharge stream at per-
sons.
•
Turn the switch off and unplug product
when unattended or at the end of
each use.
SAVE THESE INSTRUCTIONS
GROUND FAULT CIRCUIT INTERRUPTER PROTECTION
This pressure washer is provided with a ground fault circuit interrupter (GFCI) built
into the plug of the power supply cord. This device provides additional protection
from the risk of electric shock. Should replacement of the plug or cord become
necessary, use only identical replacement parts that include GFCI protection.
SERVICING OF A DOUBLE-INSULATED APPLIANCE
In a double-insulated product, two systems of insulation are provided instead of
grounding. No grounding means is provided on a double-insulated product, nor
should a means for grounding be added to the product. Servicing a double-insu-
lated product requires extreme care and knowledge of the system, and should be
done only by qualified service personnel. Replacement parts for a double insulated
product must be identical to the parts they replace. A double-insulated product
is marked with the words “DOUBLE INSULATION” or “DOUBLE INSULATED.” The
symbol may also be marked on the product.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Pressure washer
does not start
when trigger is
depressed
1. Power cord not connected
to power source
2. Switch is off
3. GFCI is tripped
4. House/shop circuit
breaker is tripped
1. Connect the power cord to a live
120V AC, 60 Hz AC receptacle.
2. Turn switch on.
3. Press reset button on the GFCI plug.
4. Reset house/shop breaker. Make
sure pressure washer is connected
to an individual branch circuit only. If
using an extension cord, make sure
it is heavy enough to carry the cur-
rent of the pressure washer.
Pump doesn’t
produce pressure
1. Inadequate water supply
2. Spray wand leaks
3. Nozzle is clogged
4. Pump is faulty
5. Air in line
6. Water inlet filter is
clogged or dirty
1. Provide adequate water flow.
2. Check connections and / or replace
wand.
3. Clean nozzle.
4. Contact authorized service center.
5. Squeeze trigger on spray wand to
remove air from line.
6. Remove the water inlet filter, rinse
with warm water, then replace in
unit.
Machine doesn’t
reach high pres-
sure
1. Diameter of garden hose
is too small
2. Water supply is restricted
3. Not enough inlet water
1. Replace with 3/4 in. garden hose.
2. Check garden hose for kinks, leaks,
and blockages.
3. Open water source full force.
No detergent
1. Detergent tank is empty
2. Water supply is inad-
equate or clogged
3. Wrong nozzle is attached
1. Add additional detergent to tank.
2. Check garden hose for kinks, leaks
and blockages.
3. Attach variable spray wand and set
to (-)
Wand leaks
O-ring needs replacing
Replace o-ring. If this does not correct
the problem, contact your authorized
service center to purchase a new
wand.
