43
Troubleshooting?
●
Warpage correction roller thermister failure. Turn off and on the power.
If the same problem recurs, turn off the power and consult our author-
ized dealers.
Overcool F6
●
The operating ambient temperature of the printer is too low. Check the
temperature. If the same problem recurs at the same operating ambi-
ent temperature, turn off the power and consult our authorized dealers.
Head Overheat F8
●
The temperature of the thermal head is too high. Turn off and on the
power. If the same problem recurs, turn off the power and consult our
authorized dealers.
Power Int. C3
●
A 24 V interruption is detected.
●
Turn off and on the power again.
Precautions on cards
Card jams
●
Check the error code on the operation panel.
Error code 90
●
Card jam in the card hopper unit.
Note:
●
Do not apply excessive force on the card hopper. Doing so may dam-
age it.
●
Do not touch the printing surface of the card. Touching it may cause
printing errors. Put on the supplied gloves when handling the cards.
1
Remove the card hopper cover.
2
Remove the loaded cards, and pull out the jammed card with a hand.
3
Install the card hopper cover.
If the card cannot be pulled out by hand
①
Open the printer door.
②
Use the jog dial to turn the retransfer unit and cleaning unit
in the clockwise direction.
Summary of Contents for EDIsecure X ID 8300
Page 14: ...14 Operation ...
Page 15: ...15 Operation ...
