Digital Identification Solutions EDIsecure X ID 8300, Instruction Manual

Page: 13 / 61

13
Operation
For setting whether to standby the printer by lowering the retrans-
fer heat roller temperature if cards are not issued for 30 minutes
or longer.
The printer will automatically restored to the original mode during
the next card issuance, but it may take a longer time before the
first card is printed. Set this to On during normal use.
Setting
●
Displays the printer settings.
Setting values
●
Display:
Mode: Counter
Counter: Total Cnt, Head Cnt, Free Cnt, Cleaning Cnt, Error Cnt
Contrast: -3, -2, -1, 0, 1, 2, 3
For setting the display status the operation panel.
●
Buzzer: On, Off
For setting whether to sound the buzzer when an error occurs or
when settings are changed.
●
Unit No: No.1 to No.10
For setting the printer’s unit number according to the USB envi-
ronment.
Option
●
Displays the optional settings.
Setting values
●
MG: None, ISO
Displays the availability of a magnetic encoder or the type of en-
coder used.
●
IC Antenna: None, Installed
Displays the availability of a non-contact IC encoder.
●
IC Contact: None, ISO Type
Displays the availability of a contact IC encoder or the type of en-
coder used.
●
Contact IC R/W: None, Installed
Displays the availability of an IC contact.
●
Bend Remedy HR: None, Installed
Displays the availability of a warpage correction heat roller.
●
Turn Over: None, Installed
Displays the availability of retransfer unit.
MG
●
Displays the coercivity settings.
Setting values
●
ISO Type: Loco, Hico
For setting the coercivity when writing data to an ISO magnetic
stripe card.
●
Retry Count: 0, 1, 2, 3
For setting the number of retries during data writing.
Network
●
Displays the network settings.
Setting values
●
Printer Name: ASCII character strings (10 characters)
For setting the printer name.
●
Host IF: LAN, USB
For setting the interface.
If the printer is connected via USB interface, the setting switches
automatically to the USB setting even if it is set to LAN during ini-
tialization.
●
[@TREX[OSD::]IPv4:
DHCP: On, Off
Setting: IP Address, Subnet Mask, Gateway
Efective IP: IP Address]
For setting IPv4.
●
[@TREX[OSD::]IPv6:
Adrs Config: Auto, Manual
Setting: IP Address, Prefix Len, Gateway
Efective IP: IP Address1, IP Address2, IP Address3]
For setting IPv6.
●
Session Time Out: Off, 10 mins, 20 mins, 30 mins, 60 mins
For setting the session timeout interval.
●
MAC Address: Hexadecimal character strings
Displays the MAC address.
●
IP Sec Mode: Off, On
For setting the availability of IP Sec.
●
IP Sec Type: not Setting, Preshard, Certificate
Displays the method for IP Sec verification.
Setting Mode Flow
●
Settings can be viewed on the printer’s operation panel.
●
Settings can be changed on the status monitor of the computer.
1
Press
［
Menu
］
●
A setting item appears.
2
Press
［
Next
］
●
Pressing it each time displays the next setting item.
●
Pressing
［
Enter
］
or
［
Change
］
displays the setting value.
●
Pressing
［
Next
］
or
A
displays the next setting value.
●
Pressing
［
Exit
］
displays the setting mode of the next higher level.