Configure security and authentication
Configure User Access Control
Digi CM User Guide
73
If you check <<Everyone>>, all users, whether they are configured locally or are using a remote
authentication (such as LDAP or Kerberos), have access to this port.
If you do not check <<Everyone>>, no users are allowed to access this port unless they are
individually listed.
When you enter usernames for access permissions or restrictions, you must enter the username
exactly as the username on the remote authentication server or configured locally. The username is
case-sensitive.
In the next example, three users are configured on the Digi CM unit: Jeff, Tim and Paul. To give Tim
and Paul read/write access and power access to this port, you could either:
▪
Grant rights to Paul and Tim
▪
Restrict Jeff’s rights
▪
Add users to an Access list (in this example. sun-users) found under System administration >
Access list. For more information, see
Configure user access privileges
To configure user access privileges:
1
Select Serial Port Configuration > All Ports (or Port #)
2
Click User access mode
3
Enter the users and their privileges, and click Add user.
Summary of Contents for Digi CM 16
Page 1: ...User Guide Digi CM 8 port 16 port 32 port and 48 port...
Page 63: ...Digi CM User Guide 63 User administration Administer users 64...
Page 130: ...Power Controller Cascade multiple Digi RPM units Digi CM User Guide 130...
Page 131: ...Digi CM User Guide 131 Port clustering Introduction 132 Configure port clustering 132...
