Digi Digi CM 16, User Manual

Page: 19 / 190

Overview SNMP
Digi CM User Guide 19
Description of fields
The following table describes the fields and the operations for the port escape feature. You will only
see the fields allowed for your permissions.
Note By entering the port escape sequence twice, it is directly transmitted (once) to the
connected device. If the escape sequence is entered twice within 1/2 second, the menu will
not open.
SNMP
An SNMP MIB to configure the Digi CM unit is available to be downloaded from digi.com/support .
Save and apply changes
In the web interface, you can save and apply configuration changes in two ways. With the one-step
method, you choose Save & apply and changes are saved and applied (take effect) immediately.
With the two-step method, you choose Save to flash , which immediately saves changes but the
changes do not take effect until you choose Apply changes. The following topics describe how to do
each of these operations.
One step: save and apply changes
To save and apply changes immediately, choose the Save & apply button.
Escape
Sequence
Ctrl+ Description of action Occurrence
m take over main session (read/write) only presented to users with read/ write access
upon entering a session
s enter as a slave session (read only) only presented to users with read/ write access
upon entering a session
b send break not functional for sniff users
l show last 100 lines of log buffer must enable logging for this option
d disconnect a sniff session only functional to admin
a send message to port user(s) not available to sniff users
r reboot device using power-switch only if power management is available on this
port
p power device on/off (show only on or off) only if power
management is available on this port
x close current connection to port closes the