Configuration menu
Firmware upgrade
Digi CM User Guide
172
5
Choose Enable/Disable unit clustering > Enable.
6
Enter the values for Slave Unit IP, No. of ports, and Port configuration.
7
Select the port number to configure or 0 for all ports.
8
Select Enable configuration
9
Select Auto Configuration
10
Choose Exit and apply changes.
Firmware upgrade
Before upgrading firmware from the configuration menu you should have:
▪
Downloaded the firmware to a system on the same subnet
▪
Set up a terminal emulation program that supports Zmodem transfer protocol
To upgrade the firmware with the configuration menu, do the following:
1
Access the configuration menu.
2
Choose System administration.
Summary of Contents for Digi CM 16
Page 1: ...User Guide Digi CM 8 port 16 port 32 port and 48 port...
Page 63: ...Digi CM User Guide 63 User administration Administer users 64...
Page 130: ...Power Controller Cascade multiple Digi RPM units Digi CM User Guide 130...
Page 131: ...Digi CM User Guide 131 Port clustering Introduction 132 Configure port clustering 132...
