System administration
Reset factory defaults
Digi CM User Guide
143
Reset factory defaults
There are two ways to reset the unit to the factory defaults. The quickest and simplest method is to
push and hold the hardware factory default reset button until the Ready light on the front panel
goes out. The reset button is located on the back panel of the unit next to the Ethernet port. The
arrow points to the reset button’s location.
The alternative method to reset the unit is through the web interface. The web interface provides
the option of retaining the IP settings. To use the web interface to reset the Digi CM unit, do the
following:
1
Access the web interface.
2 System administration
>
Configuration management
3
Under Configuration import select Factory default.
.
1
Select the Configuration factory default options you want to restore from the checklist.
2
Click
Import
. The Digi CM unit will automatically reboot.
The following are the default values when the Digi CM unit is reset to the factory defaults.
▪
Static IP Address: 192.168.161.5
▪
Port Access Menu IP Address: 192.168.1.100
▪
Port Access Menu TCP Port Number: 7000
▪
Serial Port IP Address: 192.168.1.101-
Factory reset button
Digi CM 32 shown
Summary of Contents for Digi CM 16
Page 1: ...User Guide Digi CM 8 port 16 port 32 port and 48 port...
Page 63: ...Digi CM User Guide 63 User administration Administer users 64...
Page 130: ...Power Controller Cascade multiple Digi RPM units Digi CM User Guide 130...
Page 131: ...Digi CM User Guide 131 Port clustering Introduction 132 Configure port clustering 132...
