Install and configure PC cards
Add a wireless LAN card
Digi CM User Guide
30
5
Click
Save & apply
.
Note
If DHCP is active the IP address will appear after the configuration is saved and applied.
Add a wireless LAN card
To install and configure a wireless LAN card on the Digi CM unit, do the following.
1
Insert the card into the PC slot.
2
Access the web interface.
3
Under the
PC card
heading, click
Configuration
.
Note
The card is automatically discovered and a configuration menu is displayed.
4
Click
Configure
the detected card.
5
Enter the appropriate parameters in the configuration menu.
WEP is the acronym for Wired Equivalent Privacy and is a security protocol for wireless LANs
using encryption to protect data transfers. If you are unsure of the settings for the wireless card,
see your network administrator.
SSID
- Set Service Identifier and is the name of the wireless LAN network
Use WEP key
- Enable or disable the WEP key
Summary of Contents for Digi CM 16
Page 1: ...User Guide Digi CM 8 port 16 port 32 port and 48 port...
Page 63: ...Digi CM User Guide 63 User administration Administer users 64...
Page 130: ...Power Controller Cascade multiple Digi RPM units Digi CM User Guide 130...
Page 131: ...Digi CM User Guide 131 Port clustering Introduction 132 Configure port clustering 132...
