System status and port logging
Enable the log storage location
Digi CM User Guide
37
Enable SYSLOG server
To enable the Digi CM unit for system or port logging on a syslog server:
1
Access the web interface.
2
Under the
Network
heading, click
SYSLOG server configuration
.
3
Choose Enable.
4
Enter the IP address of the primary and secondary (if applicable) syslog server, and select the
syslog facility from the drop down menu.
5
Click
Save & apply
.
Enable a compact-flash card
The compact-flash card must be installed and configured on the Digi CM unit before it can be used
for system logging or storing the Digi CM unit’s configuration information. When storing log files to
an external flash card, the size of the available storage is dependent on both the size of the card and
the port counts of the Digi CM unit used. The maximum settings for log file sizes are listed in the
following table. See also
.
Summary of Contents for Digi CM 16
Page 1: ...User Guide Digi CM 8 port 16 port 32 port and 48 port...
Page 63: ...Digi CM User Guide 63 User administration Administer users 64...
Page 130: ...Power Controller Cascade multiple Digi RPM units Digi CM User Guide 130...
Page 131: ...Digi CM User Guide 131 Port clustering Introduction 132 Configure port clustering 132...
