User administration
Administer users
Digi CM User Guide
65
4
Click
Apply Changes
.
Add an Access List to the Digi CM Unit
1
Access the web interface of the Digi CM unit.
2
Under System Configuration choose
Access Lists
.
3
Enter the access list name into the edit-box and click
[ADD]
.
4
A pop-up windows will appear confirming the successful addition of an access list. Now you can
add users to the access list by:
5
Click the name of the access list; a configuration windows will open.
6
Add one user at a time to the list by:
a. Entering the name into the edit-box and clicking
[ADD]
.
CAUTION!
Spelling is not verified against the local user database. This allows you to add
externally configured users that only exist in the RADISU, LDAP or other central
databases.
Remove a user
1. Check the box that corresponds to the user you want to remove.
2. Click
Remove
.
3. Choose
OK
at the prompt.
Create an Access list 1. Under System administration, click Access List.
2. Enter the name of the Access List and click Add.
3. Click on the access list name to add users
4. Add the users to the access list
Note: The name field in the Access list allows you to add users that are
not locally configured on the Digi CM unit but use a centralized
authentication method like RADIUS, LDAP etc.
To change the privileges of an Access list, see
To...
Do the following...
Summary of Contents for Digi CM 16
Page 1: ...User Guide Digi CM 8 port 16 port 32 port and 48 port...
Page 63: ...Digi CM User Guide 63 User administration Administer users 64...
Page 130: ...Power Controller Cascade multiple Digi RPM units Digi CM User Guide 130...
Page 131: ...Digi CM User Guide 131 Port clustering Introduction 132 Configure port clustering 132...
