Services
Configure SSH access
Digi Connect IT® 16/48 User Guide
343
c. For
Address
, enter the IPv4 address or network that can access the device's SSH
service. Allowed values are:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any
: No limit to IPv4 addresses that can access the SSH service.
d. Click
again to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
a. Click
IPv6 Addresses
.
b. For
Add Address
, click
.
c. For
Address
, enter the IPv6 address or network that can access the device's SSH
service. Allowed values are:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any
: No limit to IPv6 addresses that can access the SSH service.
d. Click
again to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the Connect IT
16/48 device:
a. Click
Interfaces
.
b. For
Add Interface
, click
.
c. For
Interface
, select the appropriate interface from the dropdown.
d. Click
again to allow access through additional interfaces.
n
To limit access based on firewall zones:
a. Click
Zones
.
b. For
Add Zone
, click
.
c. For
Zone
, select the appropriate firewall zone from the dropdown.
See
for information about firewall zones.
d. Click
again to allow access through additional firewall zones.
6. Multicast DNS (mDNS) is enabled by default. mDNS is a protocol that resolves host names in
small networks that do not have a DNS server. To disable mDNS, or enable it if it has been
disabled, click
Enable mDNS
.
7. For
Private key
, type the private key in PEM format. If
Private key
is blank, the device will use
an automatically-generated key.
8. Click
Apply
to save the configuration and apply the change.
Command line
