Services
Enable service discovery (mDNS)
Digi Connect IT® 16/48 User Guide
429
2. At the command line, type
config
to enter configuration mode:
> config
(config)>
3. Enable the mDNS service:
(config)> service mdns enable true
(config)>
4. Configure access control:
n
To limit access to specified IPv4 addresses and networks:
(config)> add service mdns acl address end
value
(config)>
Where
value
can be:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any
: No limit to IPv4 addresses that can access the mDNS service.
Repeat this step to list additional IP addresses or networks.
n
To limit access to specified IPv6 addresses and networks:
(config)> add service mdns acl address6 end
value
(config)>
Where
value
can be:
l
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any
: No limit to IPv6 addresses that can access the mDNS service.
Repeat this step to list additional IP addresses or networks.
n
To limit access to hosts connected through a specified interface on the Connect IT
16/48 device:
(config)> add service mdns acl interface end
value
(config)>
Where
value
is an interface defined on your device.
Display a list of available interfaces:
Use
... network interface ?
to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
Default IP
