Delta IED-S Series, User Manual

Page: 216 / 417

Chapter 11 Summary of Parameter Settings | IED-S
11-15
03 Function Settings
Pr. Parameter Name Setting Range Default
03-00 Hoistway Auto-tuning 0–1 0
03-01 Highest Physical Floor 1–64F 1
03-02 Lowest Physical Floor 1–64F 1
03-03 Group Control Station Number 0–7 0
03-04 Group Control Enabled
0–1
0: Single control operation
1: Group control operation
0
03-05
Main Landing for Standby While
Idling
1–64S 1
03-06
Idle Time Before Returning to the
Main Landing for Standby
0–65535 sec. 0
03-07 Car Lighting Disabled While Idling 0–65535 sec. 600
03-08 Car Fan Disabled While Idling 0–65535 sec. 30
03-09 UPS Designated Floor 0–164 0
03-10
Light Sensor and Safety Edges
Alarm
0–199 sec. 0
03-11 Service Floor 16–1 0–65535 65535
03-12 Service Floor 32–17 0–65535 65535
03-13 Service Floor 48–33 0–65535 65535
03-14 Service Floor 49–64 0–65535 65535
03-15
Automatic Safety Landing for
Severe Earthquake
0–1
0: Disabled
1: When “severe earthquake” occurs, the automatic
safety landing activates
1
03-16 Position Difference Protection 0.0–1000.0 mm 300.0
03-17 Auto-leveling After Re-power
0–3
0: Disabled
1: Runs to the bottom floor for leveling after
power-on again
2: Runs to the top floor for leveling after power-on
again
3: Automatically runs downward or upward for
leveling, depending on the elevator’s current floor
0
03-18 Delayed Time for Leveling Switch 0.000–2.000 sec. 0.200
03-19
Seismic S-wave Deceleration
Time
0.0–6553.5 sec. 7.0
03-20 Door Pre-open at Stop
0–90 mm
0: Door opens until the elevator reaches the leveling
1–90: Door opens before the elevator is near the
leveling
0
03-21 Re-leveling After Door Open
0–1
0: Re-leveling is not allowed after the door opens
1: Re-leveling is allowed after the door opens
0
03-22 Reverse Pulse Logic
0–1
0: The same as the setting direction
1: Opposite to the setting direction
0
03-23 Number of Fault Reset
0–10 times
0: Reset function is disabled
1–10: The fault automatically resets if the number of
the same fault occurred does not exceed the
Pr.03-23 setting in one hour
1
03-24 Constant Running Protection Time 1–600 sec. 120