Delta IED-S Series, User Manual

Page: 364 / 417

Chapter 12 Descriptions of Parameter Settings | IED-S
12-13-5
 The table below shows the correspondence among encoder, PG card and auto-tuning
PG Signal
Type
Setting
PG Signal Type
Applicable PG Card
x=1, 2,…
Pr.13-21=1 Pr.13-21=3
Pr.13-22=1 A, B, Z EMED-PGAB/ABD-x N/A N/A
Pr.13-22=2 A, B, Z + U, V, W EMED-PGABD-x Rolling test* 1 Rolling test* 1
Pr.13-22=3
SIN/COS + Sinusoidal
(e.g. ERN1185, ERN1387)
EMED-PGHSD-x Rolling test*
1
Pr.13-17 Bit9=0
Rolling test* 1
Pr.13-17 Bit9=1
Static test*
1
Pr.13-22=4
SIN/COS + Endat 2.1
(e.g.ECN1313, ECN413
）
EMED-PGHSD-x Dynamic test* 1 Static test* 1
Pr.13-22=5 SIN/COS EMED-PGHSD-x N/A N/A
Pr.13-22=6
SIN/COS + Hiperface
(e.g. SRS50/60)
EMED-PGHSD-x Dynamic test*
1
Static test*
1
*1 Static: Brake engaged, no motor running. Dynamic: Brake released, motor rotates less than one revolution.
Rolling: Brake released, motor rotates more than one revolution.
Encoder Pulse
Default: 2048
Settings 1–25000
 Sets the Pulses per Revolution (PPR) for the encoder.
Encoder Input Type Setting
Default: 1
Settings 0–5
0: Disabled
1: Phase A leads in a forward run command and phase B leads in a reverse
run command
2: Phase B leads in a forward run command and phase A leads in a reverse
run command
3: Phase A is a pulse input and phase B is a direction input. (low
input=reverse direction, high input=forward direction)
4: Phase A is a pulse input and phase B is a direction input. (low
input=forward direction, high input=reverse direction)