Delta IED-S Series, User Manual

Page: 312 / 417

Chapter 12 Descriptions of Parameter Settings | IED-S
12-06-5
Setting
Value
MI Function Description
UPS: The elevator must work with MI=125 BALWG
(Balanced switch) to execute safety landing. The
elevator executes downward safety landing when
BALWG is ON; executes upward safety landing
when BALWG is OFF.
55 GOV (Governor) Governor is normal when LED indicator is ON.
56 DBP (Doorlock bypass)
Doorlock bypass is the current status when LED
indicator is ON.
57
BUNC (N.C. contact of brake unit (BU)
contactor)
The N.C. contact of brake unit (BU) contactor. Used
to detect whether the BU contactor (relay) sticks or
not.
58
IBRTS (Drive’s discharge resistance
temperature switch) Discharge resistance temperature is normal when
LED indicator is ON.
59 UPK (Upward peak running)
Executes upward peak running when LED indicator
is ON.
60 DPK (Downward peak running)
Executes downward peak running when LED
indicator is ON.
61 SX1 (Door zone signal)
The elevator is currently in the door zone when LED
indicator is ON.
62 SX2 (Door unlock output feedback)
1. When the elevator is leveling, door unlock output
feedback [SX2] ON is normal as long as door
unlock output [SY] is ON.
2. When the elevator is not in inspection mode, door
unlock output feedback [SX2] OFF is normal as
long as door unlock output [SY] is OFF.
3. When error occurs on item 1 and 2, UCMP board
is abnormal, and elevator cannot run.
63
FXNO (N.O. contact of MPSCC
(Motor Phase Short Circuit
Contactor))
The N.O. contact of MPSCC. Used to detect
whether FX contactor (relay) sticks or not.
64
ERGO (Safety landing while severe
earthquake) Executes severe earthquake safety landing when
LED indicator is ON.
65
ULS4 (Fourth one upward forced
deceleration)
See description of MI=35 to MI=40.
66
DLS4 (Fourth one downward forced
deceleration)
67 UPS (Uninterruptible Power Supply)
Mains electricity is supplied by UPS when LED
indicator is ON.
Difference between EPS (MI=54) and UPS (MI=67):
EPS: The elevator can automatically determine to
execute upward safety landing or downward safety
landing.
UPS: The elevator must work with MI=125 BALWG
(Balanced switch) to execute safety landing. The
elevator executes downward safety landing when
BALWG is ON; executes upward safety landing
when BALWG is OFF.
100
OLT1 (Front door reaches its open
position)
The door is in its full open position when LED
indicator is ON. If you did not set this, door open
time by default is three seconds.
101
OLT2 (Rear door reaches its open
position)
102
CLT1 (Front door reaches its closed
position)
The door is in its full closed position when LED
indicator is ON.
103
CLT2 (Rear door reaches its closed
position)
104 EDP1 (Front door light sensor) An object is detected by the door light sensor when
LED indicator is ON. At this time, the door is unable
to act when door full close signal and doorlock
signal activate.
105 EDP2 (Rear door light sensor)