Dell PowerConnect W-Series Instant Access Point 6.1.3.4-3.1.0.0
| User Guide
Managing IAPs |
71
Chapter 5
Managing IAPs
This chapter describes the Preferred band, Auto join mode, Terminal Access, LED display, and Syslog server
features in Dell Instant. In addition, the chapter provides procedures for adding and removing IAPs, editing the
IAP settings, and upgrading the firmware on the IAP using the Instant UI.
Preferred Band
At the top right corner of Instant UI, click the
Settings
link. The
Settings
window appears.
1. In the
Settings
window, click the
General
tab.
2. Select the
Preferred band
(2.4GHz, 5 GHz, All) from the drop-down list for single-radio access points.
Auto Join Mode
The Auto Join Mode feature allows IAPs to automatically,
1. Discover the Virtual Controller.
2. Join the network.
3. Begin functioning.
The
Auto Join Mode
feature is enabled by default. When the Auto Join Mode feature is disabled, a
New
link
appears in the
Access Points
tab. Click this link to add IAPs to the network. For more information, see
“Adding
an IAP to the Network” on page
79
. Also, when this feature is disabled, IAPs that are configured but not active
appear in red.
Disabling Auto Join Mode
To disable Auto Join Mode, perform the following steps:
At the top right corner of Instant UI, click the
Settings
link. The
Settings
window appears.
1. In the
Settings
window, click the
General
tab.
2. Select
Disabled
from the
Auto join mode
drop-down list.
NOTE:
Reboot the IAP after configuring the radio profile settings in order for the changes to take effect.
Summary of Contents for PowerConnect W-IAP3WN
Page 1: ...Dell PowerConnect W Series Instant Access Point 6 1 3 4 3 1 0 0 User Guide ...
Page 10: ...10 Contents Dell PowerConnect W Series Instant Access Point 6 1 3 4 3 1 0 0 User Guide ...
Page 106: ...106 NTP Server Dell PowerConnect W Series Instant Access Point 6 1 3 4 3 1 0 0 User Guide ...
Page 134: ...134 Authentication Dell PowerConnect W Series Instant Access Point 6 1 3 4 3 1 0 0 User Guide ...