196
| Dell PowerConnect W-AirWave Integration and Management
Dell PowerConnect W-Series Instant Access Point 6.1.3.4-3.1.0.0
| User Guide
This method describes how to set up a DHCP server to send option 43 with Dell PowerConnect W-AirWave
information to Dell Instant IAP. This section assumes that option 43 will be sent per scope since option 60 is
being shared by other devices as well.
1. In server 2008, go to
Server Manager
> Roles > DHCP Server >
Your
Domain DHCP Server > IPv4
.
2. Select a scope (subnet). Scope (10.169.145.0)145 is selected in the example shown in Figure below.
3. Right click and select
Advanced
and then specify the following options:
Vendor class— DHCP Standard Options
User class— Default User Class
Available options— Select 043 Vendor Specific Info
String Value— Dell InstantAP, tme-store4, 10.169.240.8, Dell123 (which is the AP description,
organization string, Dell PowerConnect W-AirWave IP address, Pre-shared key for Dell PowerConnect
W-AirWave).
Figure 169
Vendor Specific DHCP options
Upon completion, the IAP shows up as a new device in Dell PowerConnect W-AirWave, and a new group called
tme-store4 is created. Navigate to
APs/Devices > New > Group
to view this group.
NOTE:
This scope should be specific to instant and the PXE devices that use options 60 and 43 should not connect to the subnet
defined by this scope.This is because you can specify only one option 43 for a scope and if other devices that use option 43
connect to this subnet, they will be presented with Instant specific information.
Summary of Contents for PowerConnect W-IAP3WN
Page 1: ...Dell PowerConnect W Series Instant Access Point 6 1 3 4 3 1 0 0 User Guide ...
Page 10: ...10 Contents Dell PowerConnect W Series Instant Access Point 6 1 3 4 3 1 0 0 User Guide ...
Page 106: ...106 NTP Server Dell PowerConnect W Series Instant Access Point 6 1 3 4 3 1 0 0 User Guide ...
Page 134: ...134 Authentication Dell PowerConnect W Series Instant Access Point 6 1 3 4 3 1 0 0 User Guide ...
