DCT Antares SB, User Manual

Page: 47 / 238

3.3. INPUTS/IGNITION
Logical State Electrical State
Active 0V to 1V
Inactive 2.9V to 32V or Open
For the ignition input:
State Voltage range
Ignition ON 5.8V to 32V
Ignition OFF 0V to 4.8V or Open
For addition Inputs’ state can be consulted locally or remotely at any
time with the TAIP console.
Inputs are used to create events’ triggers on the Event Machine thus
generating reports depending on the inputs’ state/changes.
To create input dependent events and to consult inputs’ state the
Event Machine’s
IP
signals are used. These signals are true whenever
the corresponding input is true . For information on signals consult
the Event Machine section on the Configuration chapter.
The corresponding signals are:
Input Signal name Old signal name
Input 1
IP1 G00
Input 2
IP2 G01
Input 3
IP3 G02
Input 4
IP4 G03
Ignition
F00 F00
Inputs can be monitored with the
SS
TAIP message.
To consult the state of Input 3: Example
Using the TAIP console send to the unit:
>
QSSIP3
<
For an active input (i.e. input 3 at GND) the unit returns:
>
RSSIP31
<
and when the input is not active (i.e. input 3 at any voltage
4
or
disconnected):
>
RSSIP30
<
4
The maximum supported voltage for inputs is 32 volts.
45