DCT Antares SB, User Manual

Page: 150 / 238

6.5. (ED) EVENT DEFINITION
6.5.1 Examples
Single signal triggers
To define event 05 to send an EV Event Message every 3 minutes:
Example: Periodic report
1. Use the TD message to configure a Time & Distance signal to trigger
every 3 minutes:
>
STD70180
<
2. Define the event with signal TD7 as trigger:
>
SED05NV0;TD7+
<
Note that DA0 ( Destination Address 0 ) must be defined so that the Event
Message can be routed to any IP address(es) and/or SMS(s) receiver(s).
If the message were not to be routed, the Event Definition message should
be:
>
SED05SV0;TD7+
<
The only purpose of this event is to drive the
E05
signal true or false ac-
cording to the event’s trigger (TD7+) in order to trigger any other event(s)
that include
E05
as part of its trigger definition.
Send an Event Message when an input gets active:
Example: Panic button
>
SED31NV0;IP3+
<
This definition will make the unit send an EV Event Message with code
31 every time the input 3 becomes true.
Have the unit initiate a time counter, set an user signal true and reset
Example: Several actions
per event
a distance counter whenever the vehicle’s ignition goes high:
>
SED35SV0;F00+;ACT=SGC05TC;ACT=SSSU041;ACT=SGC07U
<
Have the unit send an extended-EV report that includes the Altitude, In-
Example: Reporting an
extended-EV message
put/Outputs state and number of satellites in view whenever the input 1 is
activated:
>
SED23NA0;IP1+;
<
Define the extended-EV message A with the desired information tags:
>
SXAEFA;AL;IO;SV;
<
148