DCT Antares SB, User Manual

Page: 117 / 238

5.4. ADDING VOICE INTERACTION
phone number 912345678 the text message:
>
SSSXP21
<
The unit responds the following via SMS:
>
RSSXP21
<
Confirming that it accepted the command and the output has been set
high.
5.4 Adding voice interaction
The unit may receive or make calls from/to any of the Phone Number-type
defined
Destinations . To initiate a voice call to a DP the
XAVC
message is
used. To receive voice calls the remote Phone Number has to be defined on
a Phone-Number-type destination and the
Access parameter on the
DP
defi-
nition has to indicate that an incoming call from that DP is to be answered.
5.4.1 Make the unit accept a phone call
To do so the Access parameter on the corresponding DP has to indicated
voice call access. In our previous example the 912345678 Phone Number
was defined with the
XADP
messages as follows:
>
SXADP1010912345678
<
The Access is such that voice calls from that number are to be answered.
Any incoming call from the 912345678 is now going to be answered. The
voice call is maintained until the
912345678 decides to hung-up.
For more information on the Access parameter see the
XADP
message.
5.4.2 Have the unit initiate a voice call
This can be done manually by using the
XAVC
message.
To initiate a voice call to the Phone Number defined on the Adding SMS
reporting example send to the unit:
>
SXAVC10
<
The unit returns immediately:
>
RXAVC10
<
Indicating it has accepted the command and that the voice call dial up
has initiated. No failure/success indication is thrown at a later time. To
monitor the voice call the fixed voice signals have to be used.
To end the voice call, send:
>
SXAVE
<
115