![background image](http://html1.mh-extra.com/html/daum-electronic/8008-trs3/8008-trs3_user-manual_514129055.webp)
53
Simple Maintenance and Service Activities
3
3
3
1
2
CP
right side
Miscellaneous
Every 500 km of cumulated running distance you should check whether all the screws are still firmly set. Tighten them
back as needed.
Care should be taken to remove sweat from the dashboard and the frame after every training session to protect the
paint against rust. Rust damage caused by sweat is not covered by the warranty!
Use a soft cloth wetted with water to clean the outer surface of the device. A light soap solution may also be used to
wet the cloth.
III
Replacing the V-belt
Required tools:
1
1
1
crank puller (CP / commercially available)
Phillips screwdriver
8mm Allen wrench
Procedure to replace the V-belt
Unplug the power cable from the main power supply before opening the device!
Take particular care to avoid damaging the internal parts of your ergo_bike while you are working.
The manufacturer will not be liable for any damages arising as a result of negligence while
changing the V-belt!
V-belts are wearable parts and as such are not covered by the warranty.
Remove the protective cap (1) of the axle centre.
Loosen the screw attaching the pedal rod (2).
(8mm Allen wrench).
Screw in an appropriate M 12 bolt, with a hexadecimal
or recessed head, into the thread of the pedal axle until
the pedal comes off the axle shaft. Hold the pedal firmly
and remove it.
Loosen the screws (3) on the lower right side cover.
Carefully remove the side cover.
The driving parts on the carrier plate /drive unit are now
freely accessible. Press on the belt tension lever and the
tension spring (9h) to release the V-belt tension, and then
pull the belt from the pulley (9a).
Before installing the new V-belt, you should clean the belt
slipping surfaces of the pulley and the drive shaft, as well
as the belt itself, with alcohol or cleaning petrol to remove
the grease.
Follow the same steps (1 to 6) as described above in
reverse sequence to install the new V-belt.
1.
2.
3.
4.
5.
The V-belt is located on the right side of the device.
6.
9a
9r
9p
Spring
9h
Tension
lever
9g
9c
Summary of Contents for 8008 TRS3
Page 1: ...8008 TRS3 3 3 User Manual ...
Page 59: ......