3.
-
-
4.
-
-
e3
0b
h2
77
.1
0
Illustration 31: Cutting the Grommet in IP54
e3
0b
h2
78
.1
0
Attach the grommet and the cable until the frame of the drive goes into the groove of the grommet.
With the protection rating IP54 (UL Type 12), the connection between the grommet and the cable must be tight. Pull
the first bit of the cable out of the grommet until it stays straight.
If this is not possible, make the connection tight with some insulation tape or a cable tie.
e
3
0
b
g
0
7
7
.1
0
Connect the cables. See the correct tightening torques in
12.6 Tightening Torques of the Terminals
Connect the phase conductors of the mains cable and of the motor cable into the correct terminals. If a brake resistor
cable is used, connect its conductors into the correct terminals.
Attach the grounding conductor of each cable to a grounding terminal with a grounding clamp for grounding con-
ductor.
AQ275638903263en-000601 / DPD00910
70 | Danfoss A/S © 2022.12
Electrical Installation
VACON® NXS/NXP Air-cooled
Operating Guide
