A
The [ready] LED is on when the AC power is connec-
ted to the drive and no faults are active. At the same
time, the drive status indication shows
READY
.
B
The [run] LED is on when the drive operates. The
LED blinks when the Stop button is pushed and the
drive ramps down.
C
The [fault] LED blinks when the AC drive is stopped
because of dangerous conditions (Fault Trip). See
8.5.1 Finding the Active Faults Menu
.
D
The Start button. When the keypad is the active con-
trol mode, this button starts the motor. See
E
The Stop button. The button stops the motor (unless
the stop is disabled by the parameter R3.4/R3.6). See
8.4.2 Keypad Control Parameters M3
F
The Menu button Right. Use it to move forward in
the menu, move the cursor right (in the parameter
menu) and to go to the edit mode.
G
The [enter] button. Use it to accept a selection, reset
the fault history (push for 2–3 s).
H
The Browser button Down. Use it to scroll the main
menu and the pages of different submenus and to
decrease a value.
I
The [select] button. Use it to move between 2 last
displays, for example, to see how new value
changes some other value.
J
The Menu button Left. Use it to move back in the
menu, move the cursor left (in the Parameter menu).
K
The [reset] button. Use it to reset a fault.
L
The Browser button Up. Use it to scroll the main
menu and the pages of different submenus and to
increase a value.
K
A
B
C
L
D
E
J
F
I
H
G
reset
START
STOP
ready run fault
select
enter
e
3
0
b
g
0
7
2
.1
0
Illustration 3: Keypad Buttons for VACON
®
NXS
AQ275638903263en-000601 / DPD00910 | 25
Danfoss A/S © 2022.12
Product Overview
VACON® NXS/NXP Air-cooled
Operating Guide
