Danaher Motion B8961, Operator'S Manual

Page: 37 / 158

Chapter 4 - Configuring Your System
35
Order Code I/O Module Description Opto-22 Grayhill P/N
(p/n) P/N
A (PCB-1210) 10-32 VAC/VDC Input G4IDC5
B (PCB-1211) TTL Input G4IDC5K
C (PCB-1212) 35-60V DC Input G4IDC5G
D (PCB-1213) 90-140 VAC Input G4IAC5
E (PCB-1214) 180-240 VAC Input G4IAC5A
F (PCB-1215) 5-60 VDC, 3 Amps Output G4ODC5
G (PCB-1216) 12-140 VAC, 3 Amps Output G4OAC5
H (PCB-1217) Output 24-280 VAC, 3 Amps G4OAC5A
I (PCB-1218) Input Test Switch G4SWIN
J (PCB-1219) 0-10 Volt Analog Input 73G-IV10
K (PCB-1220) 4-20 mA Analog Input 73G-II420
L (PCB-1221) 0-10 Volt Analog Output 73G-OV10
M (PCB-1222) 4-20 mA Analog Output 73G-OI420
N (PCB-1223) J Type Thermocouple Input, 73G-ITCJ
0 to 700˚C
O (PCB-1319) K Thermocouple Input,
-100 to 924˚C
P (PCB-1224) RTD Thermocouple Input, 73G-ITR100
100 Ohm
More information on available OPTO modules is available from the Opto module
manufacturer or your local distributor.
Configuring Ouput States on Power Up [OEP]
Default: OFF
This option.sets the desired states of the outputs on
power up.
1.Use
ß
and
à
keys to scroll throu outputs #1 – #8 and any OPTO positions
configured as outputs.
2.Use the
á
and
â
keys to set the output state as OFF or ON and press ESC
to register.
Configuring Ouput States on Fault [OEF]
Default: NO CHANGE
This option.sets the desired states of the outputs on a
fault.
1.Use
ß
and
à
keys to scroll throu outputs #1 – #8 and any OPTO positions
configured as outputs.
2.Use the
á
and
â
keys to set the output state as OFF, ON or NO CHANGE and
press ESC to register.
EDIT > SETUP > I/O > OUTSTS > FAULT
- On Fault Output #1 -
ßâ
NO CHANGE
áà
EDIT
> SETUP > I/O > OUTSTS > PWR-UP
- On PwrUp Output #1 -
ßâ
OFF
áà