ED34-862
Accessories
FXFQ-P
113
2
JC : 3K015219E
Decoration panel
Filter chamber
M4 × 12 screws
(Supplied with indoor unit main body)
Filter chamber
Filter chamber
Decoration panel
Swing motor lead wire:
Route from the panel side to the
filter chamber.
(After temporarily hooking the
decoration panel, pass through
the wire through hole.)
Sealing pad (supplied): For preventing air bypass
(Stick to 2 positions in the same manner.)
wire through hole
Indoor unit
main body
Ceiling surface
Before mounting each filter to the chamber,
cut off at the perforation (2 positions).
Suspension bracket
Preparation of Indoor Unit
Installation pattern paper
(Supplied with indoor unit main body)
Both 80 and 160
•
Install the indoor unit main body and filter chamber.
At the time of installation, perform engineering work according to the installation manual
attached to the air conditioner's main body. (For the installation height, refer to the figure to
the right.)
• After temporarily hooking the decoration panel, pass the swing motor lead wire, which is coming out from the decoration panel, through the wire through hole of the filter chamber.
• Mount the decoration panel according to the installation manual attached to the decoration panel.
Approximately every 10,000 hours
1
02
10 or 20
Filter name
Initial setting for ultra-long life filter
Installation of Indoor Unit Main Body and Filter Chamber
Mounting of Decoration Panel and Mounting of Filter Chamber
02
Filters
[Mounting of installation pattern paper]
•
Complete all the refrigerant and drain piping work for the indoor unit main body.
02
Where there is considerable fouling
(Example: Pachinko parlor, etc.)
0
13 or 23
Setting switch number
(Installation height
guideline)
01
Setting position number
0
Where there is minimal fouling
(Example: Office, etc.)
BYCP125K-W1
Filter clasp
80 only
Filter sign display interval time
1
•
Mounting of filter
After the completion of wiring and sticking of sealing pad (2 positions), mount the filter.
Figure 5 Figure 6
Rotate the filter clasp by 90˚
to fix the filter.
(2 positions)
•
When mounting the filter chamber to the existing indoor unit main body, change the
installation height of the indoor unit main body to height in the figure to the right.
180
With wireless unit
•
Route the connector of the receiver lead wire through the wire through hole, then connect the connector on the indoor PC board assembly.
•
For details on the connection method, refer to the installation manual attached to the wireless remote control kit (sold separately).
Mode number
02
Ultra-long life filter
Approximately every 5,000 hours
(mm)
High
performance
filter
•
Mount the supplied installation pattern paper to the indoor unit using screws
to cure the indoor unit.
(Refer to the installation manual of the indoor unit main body.)
(Refer to the figure below.)
Figure 5
Figure 6
• Depending on the types of mounting filters, setting the
indoor unit main body is may be required.
Using the field setting mode on the remote control, switch
to the setting position number shown in the table to the right.
For the field setting mode, refer to "How to perform field
setting" attached to the remote control.
Все каталоги и инструкции здесь:
http
:
//splitoff.ru/tehn-doc.html