Operation Manual
SiMT041311E
83
Installation / Operation Manual
9
3
3
2
2
1
1
Upper tab
Hole
Projection
Preparation before operation
Do not confuse
the and sides.
Remote controller
holder
Lower tab
(2 locations)
Screws
To set the batteries
1.
Pull down the upper tab to open the
cover.
2.
Insert 2 dry batteries AA.LR6 (alkaline).
3.
Insert the 2 lower tabs on the cover to
put the cover back in place.
To fix the remote controller holder to a wall
1.
Choose a place where the signals can
reach the unit.
2.
Fix the remote controller holder to a wall, a
pillar, or similar location with the screws
procured locally.
3.
Fit the projection of the remote controller
holder into the hole at the back of the
remote controller.
Turn on the circuit breaker
• After the power is turned on, the flaps of the indoor unit open and
close once to set the reference position.
• Using batteries other than AA.LR6 (alkaline) may lead to
improper operation.
Notes on batteries
• The batteries will last for about 1 year. If the remote controller display begins to fade and the reception degrades within
1 year, however, replace both batteries with new AA.LR6 (alkaline) ones at the same time.
• The batteries that come with the remote controller are for initial operation. The batteries may run out in less than 1 year.
• When the TIMERS are set, the settings are cancelled after replacing the batteries. Set the TIMERS again.
• When the air conditioner is not used for a long time, take the batteries out.