![background image](http://html1.mh-extra.com/html/daikin/ftks50bvmb/ftks50bvmb_service-manual_501473288.webp)
Ceiling Mounted Cassette Type
SiEN18-622
276
System Configuration
Clean the air filter and outside panels
•
After cleaning the air filter, make sure to attach it.
Turn on the main power supply switch
•
The display on the remote control will be shown when the
power is turned on.
•
To protect the unit, turn on the main power switch at least
6 hours before operation.
What to do when stopping the system for a long
period
Turn on FAN OPERATION for half a day and dry the unit.
•
Refer to “Fan operation”.
Cut off the power supply.
•
When the main power switch is turned on, some watts of
electricity is being used even if the system is not operating.
Turn off the main power supply switch for saving energy.
•
The display on the remote control will vanish when the
main power switch is turned off.
Clean the air filter and the exterior.
•
Be sure to replace the air filter to its original place after
cleaning. Refer to “Maintenance”
The following symptoms do not indicate air conditioner
malfunction.
I. The system does not operate
•
The system does not restart immediately after the ON/
OFF button is pressed.
If the OPERATION lamp lights, the system is in normal
condition.
It does not restart immediately because a safety device
operates to prevent overload of the system. After 3
minutes, the system will turn on again automatically.
•
The system does not restart immediately when
TEMPERATURE SETTING button is returned to the
former position after pushing the button.
If the OPERATION lamp lights, the system is in normal
condition.
It does not restart immediately because a safety device
operates to prevent overload of the system. After 3
minutes, the system will turn on again automatically.
•
The system does not start when the display shows
“
” (UNDER CENTRALIZED CONTROL) and it
flashes for few seconds after pressing an operation
button.
This is because the system is under centralized control.
Flashes on the display indicate that the system cannot be
controlled by the remote control.
•
The system does not start immediately after the power
supply is turned on.
Wait one minute until the micro computer is prepared for
operation.
II. White mist comes out of a unit
•
When humidity is high during cooling operation.
(In oily or dusty places)
If the inside of an indoor unit is extremely contaminated,
the temperature distribution inside a room becomes
uneven. It is necessary to clean the inside of the indoor
unit. Ask your Daikin dealer for details on cleaning the unit.
This operation requires a qualified service person.
•
When the system is changed over to HEATING
OPERATION after DEFROST OPERATION.
Moisture generated by DEFROST becomes steam and
exists.
III. Noise of air conditioners
•
A ringing sound after the unit is started.
This sound is generated by the temperature regulator
working. It will quiet down after about a minute.
•
A continuous flow “Shuh” sound is heard when the
system is in COOLING or DEFROST OPERATION.
This is the sound of refrigerant gas flowing through both
indoor units.
•
A “Shuh” sound which is heard at the start or
immediately after the stop of operation or which is
heard at the start or immediatly after the stop of
DEFROST OPERATION.
This is the noise of refrigerant caused by flow stop and
flow change.
•
A continuous flow “Shuh” sound is heard when the
system is in COOLING OPERATION or at a stop.
The noise is heard when the drain pump is in operation.
•
A “Pishi-pishi” squeaking sound is heard when the
system is in operation or after the stop of operation.
Expansion and contraction of plastic parts caused by
temperature change make this noise.
IV. Dust from the units
•
Dust may blow out from the unit after starting
operation from long resting time.
Dust absorbed by the unit blows out.
V. The units give off odors
The unit absorbs the smell of rooms, furniture, cigarettes,
ect., and then emits them.
VI. The liquid crystal of the remote control shows
“88”
•
It happens immediately after the main power supply
switch is turned on.
This shows that the remote control is in normal condition.
This continues temporary.
9. Not malfunction of the air conditioner
Summary of Contents for FTKS50BVMB
