Daikin FTKS50BVMB, Service Manual

Page: 225 / 456

SiEN18-622 Instruction
System Configuration 213
Notes on flaps and louvers angles
„
To adjust the vertical blades (louvers)
Hold the knob and move the louvers.
(You will find a knob on the left-side and the right-side blades.)
• When the unit is installed in the corner of a room, the
direction of the louvers should be facing away from the
wall. If they face the wall, the wall will block off the wind,
causing the cooling (or heating) efficiency to drop.
• When “SWING button” is selected, the flaps swinging range depends
on the operation mode. (See the figure.)
• If the unit is operated after being stopped with the flaps pointed down in
cooling or dry operation, the flaps will automatically move to a
horizontal position after about one hour to prevent condesnation from
forming on them.
„ ATTENTION
•
Always use a remote control to adjust the flaps angle. If you attempt to
move it forcibly with hand when it is swinging, the mechanism may be
broken.
• Be careful when adjusting the louvers. Inside the air outlet, a fan is
rotating at a high speed.
In DRY mode or COOL mode
When stop operation
Upper limit
Lower limit
In HEAT mode
In FAN mode
When stop operation
Upper limit
Lower limit
Lower limit
Upper limit
When stop operation