![background image](http://html.mh-extra.com/html/daikin/2amx40g2v1b/2amx40g2v1b_service-manual_501057168.webp)
Instruction
SiBE12-933_A
158
Operation Manual
Press the AIR FLOW DIRECTION ADJUST
button to select the air direction as following.
PROGRAMMING TIME
The AIR FLOW FLAP display
swings as shown left and the
air flow direction continuously
varies. (Automatic swing
setting)
Press the PROGRAMMING TIME button
and set the time for stopping or starting
the system.
Press AIR FLOW DIRECTION
ADJUST button to select the
air direction of your choice.
When this button is pressed, the
time advances by 1 hour.
When this button is pressed, the
time goes backward by 1 hour.
The AIR FLOW FLAP display
stops swinging and the air
flow direction is fixed (Fixed
air flow direction setting).
TIMER ON/OFF
Press the TIMER ON/OFF button.
MOVEMENT OF THE AIR FLOW FLAP
For the following conditions, micro computer
controls the air flow direction so it may be different
from the display.
The timer setting procedure ends.
The display “
or
” changes from
flashing light to a constant light.
Refer to figure 4 on page [1]
Operation
mode
Heating
NOTE
• When setting the timer Off and On at the same
time, repeat the above procedure from
1
to
3
once again.
When the timer is programmed to stop the system
after 3 hours and start the system after 4 hours,
the system will stop after 3 hours and then 1 hour
later the system will start.
• After the timer is programmed, the display shows
the remaining time.
• Press the TIMER ON/OFF button once again to
cancel programming. The display vanishes.
Operation
condition
• When starting operation
• When room temperature is higher
than the set temperature
• At defrost operation
(Air is blown horizontally to prevent
the cool air from being blown
directly onto anyone in the room.)
Operation mode includes automatic operation.
PROGRAM TIMER OPERATION
Operate in the following order.
• The timer is operated in the following two ways.
• Programming the stop time (
) .... The
system stops
operating after the set time has elapsed.
• Programming the start time (
) .... The
system starts
operating after the set time has elapsed.
• The timer can be programmed a maximum of 72
hours.
• The start and the stop time can be
simultaneously programmed.
7. OPTIMUM OPERATION
Observe the following precautions to ensure the
system operates.
• Adjust the room temperature properly for a
comfortable environment. Avoid excessive
heating or cooling.
• Prevent direct sunlight from entering a room
during cooling operation by using curtains or
blinds.
• Ventilate the room regularly.
Using the unit for long periods of time requires
attentive ventilation of the room.
• Do not place items that might be damaged by
water under the indoor unit.
Water may condensate and drip if the humidity
reaches 80% or if the drain exit gets clogged.
• Keep doors and windows closed. If the doors and
windows remain open, room air will flow out and
cause to decrease the effect of cooling and
heating.
TIMER MODE START/STOP
Press the TIMER MODE START/STOP
button several times and select the mode
on the display.
The display flashes.
For setting the timer stop .... “
”
For setting the timer start .... “
”
2
swing
3
1