Daewoo Lanos 2002, Owner'S Manual

Page: 95 / 174

5–32 AUDIO SYSTEM* (RADIO, CASSETTE AND CD PLAYER)
RADIO OPERATION
1. Press the power knob (1) or AM/FM
button to turn the audio system on.
2. Press the "AM/FM" button (3) to select
the desired band.
Band changes as follows ;
→
FM1
→
FM2
→
AM(MW)
→
LW
3. Tune in the desired station using seek
tuning, manual tuning, preset button or
preset scan function.
4. To hear the preset station stored on the
preset buttons, use the preset scan
button.
5. To turn the radio on while operating CD
player or cassette, press the "AM/FM"
button (3).
Preset Scan :
To hear the preset station stored on the pre-
set buttons, press the preset scan button
(14) for less than 2 seconds.
In FM(FM1 or FM2) band, all of the preset
stations stored on the preset buttons in the
FM1 or FM2 band will be tuned in for about
5 seconds each in turn.
In AM band, all of the preset stations stored
on the preset buttons in the AM band will
be tuned in for about 5 seconds each in
turn.
During operating this function, the relevant
frequency and preset button number will be
flashed on the V.F.D.
After scanning all of the preset stations,
this function is automatically cancelled and
the station you heard before operating this
function is tuned in.
When desired station is tuned in, press this
button again or the corresponding preset
button to stop the scan function.
How to Tune in the Desired Station
Seek Tuning :
Use the seek buttons (16) to quickly search
for a station.
To search for next receivable lower station,
press the " " button.
To search for next receivable higher station,
press " " button.
Manual Tuning :
Press the tuning up ( ) or down ( )
buttons (16) to increase or decrease the fre-
quency. The frequency of AM band changes
9 kHz (or 5 kHz or 10 kHz) each time and
that of FM band changes 50 kHz (or 100 kHz
or 200 kHz) each time.
Using Preset Buttons :
To select the desired preset station stored
on the preset buttons, press the correspond-
ing preset button for less than 1 second.
NOTE
Audio system can be operated when
the ignition key is at "ACC" or "ON"
position.