xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
NOTE:
The Switch's factory default IP address is 10.90.90.90 with a
subnet mask of 255.0.0.0 and a default gateway of 0.0.0.0.
IPv6 Interface Settings
The following window is used to setup IPv6 interfaces and addresses for the switch.
To view this window, click
L3 Features
>
Interface Settings >
IPv6 Interfaces Settings
, as shown below:
Figure 4- 4. IPv6 Interface Settings window
To remove an entry from the table, click its corresponding
under the Delete heading.
To add a new IPv6 interface, click the
Add
button, which will display the following window.
Figure 4- 5. IPv6 Interface Settings – Add window
To add an Interface, enter an Interface Name
in the field provided, along with a corresponding VLAN Name, set the Interface
Admin. State
to
Enabled
and click
Apply
. Newly created interfaces will appear in the
IPv6 Interface Settings
window.
To change the settings for a configured Interface, click the corresponding
Modify
button, which will display the following
window for the user to configure.
175
