xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
131
DGS-3450:admin#show cfm mp_ltr_all
Command: show cfm mp_ltr_all
All MPs reply LTRs: Enabled
DGS-3450:admin#
show cfm remote_mep
Purpose
Used to show remote MEPs.
Syntax
show cfm remote_mep [mepname <string 32> | md [<string 22> | md_index <uint 1-
4294967295>] ma [<string 22> | ma_index <uint 1-4294967295>] mepid <int 1-8191>]
remote_mepid <int 1-8191>
Description
This command is used to show remote MEPs.
Parameters
mepname <string 32>
- Specify the MEP name.
md <string 22>
- Specify the Maintenance Domain name.
md_index <uint 1-4294967295>
- Specify the Maintenance Domain index.
ma <string 22>
- Specify the Maintenance Association name.
ma_index <uint 1-4294967295>
- Specify the Maintenance Association index.
mepid <int 1-8191>
- Specify the MEP ID.
remote_mepid <int 1-8191>
- Specify the remote MEP ID.
Restrictions
None.
Example usage:
To show the CFM remote MEP information:
DGS-3450:admin#show cfm remote_mep mepname mep1 remote_mepid 2
Command: show cfm remote_mep mepname mep1 remote_mepid 2
Remote MEPID : 2
MAC Address : 00-11-22-33-44-02
Status : OK
RDI : Yes
Port State : Blocked
Interface Status : Down
Last CCM Serial Number : 1000
Sender Chassis ID : 00-11-22-33-44-00
Sender Management Address: SNMP-UDP-IPv4 10.90.90.90:161
Detect Time : 2012-09-12 12:00:00
DGS-3450:admin#
show cfm pkt_cnt
Purpose
Used to show the CFM packet’s RX/TX counters.
Syntax
show cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Description
This command is used to show the CFM packet’s RX/TX counters.
Parameters
ports <portlist>
- Specify the port counters to be displayed.
{[rx | tx]}
- Show the RX or TX counters. If not specified, both counters will be shown.
[rx | tx]
- Show the RX or TX counters of all ports.
ccm
- Show the CCM RX counters of all ports.
