xStack
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
377
config lldp ports admin_status
Purpose
Used to configure per-port transmit and receive modes.
Syntax
config lldp ports [<portlist>|all] admin_status [tx_only | rx_only | tx_and_rx | disable]
Description
These options enable the user to control which ports participate in LLDP traffic and whether
the participating ports allow LLDP traffic in only one direction or in both directions.
Parameters
<portlist>
–
Use this parameter to define ports to be configured.
all
– Use this parameter to set all ports in the system.
admin_status
–
tx_only
: Configure the specified port(s) to transmit LLDP packets, but block
inbound LLDP packets from neighbor devices;
rx_only
: Configure the specified port(s) to
receive LLDP packets from neighbors, but block outbound packets to neighbors;
tx_and_rx
:
Configure the specified port(s) to both transmit and receive LLDP packets;
disable
: Disable
LLDP packet transmit and receive on the specified port(s). The default per port state is
tx_and_rx
.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To configure ports 1 to 5 to transmit and receive:
DGS-3450:admin# config lldp ports 1:1-1:5 admin_status tx_and_rx
Command: config lldp ports 1:1-1:5 admin_status tx_and_rx
Success.
DGS-3450:admin#
config lldp ports mgt_addr
Purpose
Used to enable or disable port(s) specified for advertising indicated management address
instance.
Syntax
config lldp ports [<portlist>|all] mgt_addr [ipv4 <ipaddr> | ipv6 <ipv6addr>] [enable |
disable]
Description
This command specifies whether the system’s IP address needs to be advertised from the
specified port. For layer 3 devices, each managed address can be individually specified. The
management addresses that are added in the list will be advertised in the LLDP from the
specified interface associated with each management address. The interface for that
management address will be also advertised in the if-index form
Parameters
<portlist>
–
Use this parameter to define ports to be configured.
all
– Use this parameter to set all ports in the system.
ipv4
– The IP address of IPv4.
Ipv6
– The IP address of IPv6.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example usage:
To enable ports 1 to 2 to manage address entry:
