DGS-3024 Layer 2 Switch CLI Reference Manual
16
L
INK
A
GGREGATION
C
OMMANDS
The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create link_aggregation group_id <value 1-4>
delete link_aggregation group_id <value 1-4>
config link_aggregation
group_id <value 1-4> {master_port <port> | ports <portlist> | state
[enable | disable]}
config link_aggregation
algorithm
[mac_source | mac_destination | mac_source_dest]
show link_aggregation
{group_id <value 1-4> | algorithm}
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose
Used to create a link aggregation group on the Switch.
Syntax
create link_aggregation group_id <value 1-4>
Description
This command will create a link aggregation group with a unique identifier.
Parameters
<value 1-4>
−
Specifies the group ID. The Switch allows up to 4 link
aggregation groups to be configured. The group number identifies each of
the groups.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To create a link aggregation group:
DGS-3024:4#create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DGS-3024:4#
95
delete link_aggregation group_id
Purpose
Used to delete a previously configured link aggregation group.
Syntax
delete link_aggregation group_id <value 1-4>
Description
This command is used to delete a previously configured link aggregation
group.
Parameters
<value 1-4>
−
Specifies the group ID. The Switch allows up to 4 link
i
b
fi
d Th
b
id
ifi
h f
