DGS-3024 Layer 2 Switch CLI Reference Manual
17
B
ASIC
IP C
OMMANDS
The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config ipif
<ipif_name 12> [{ipaddress <network_address> | vlan <vlan_name 32> |
state [enable | disable]} | bootp | dhcp]
show ipif
{<ipif_name 12>}
Each command is listed, in detail, in the following sections.
config ipif System
Purpose
Used to configure the System IP interface.
Syntax
config ipif System [{ipaddress <network_address> | vlan <vlan_name
32> | state [enable | disable]} | bootp | dhcp]
Description
This command is used to configure the System IP interface on the Switch.
Parameters
System
- The IP interface name to be configured. The default IP Interface
name on the Switch is “System”. All IP interface configurations done will be
executed through this interface name.
<network_address>
−
IP address and netmask of the IP interface to be
created. The address and mask information may be specified by using the
traditional format (for example, 10.1.2.3/255.0.0.0 or in CIDR format,
10.1.2.3/16).
<vlan_name 32>
−
The name of the VLAN corresponding to the System IP
interface.
state [enable | disable]
−
Used to enable or disable the IP interface.
bootp
−
Allows the selection of the BOOTP protocol for the assignment of
an IP address to the Switch’s System IP interface.
dhcp
−
Allows the selection of the DHCP protocol for the assignment of an
IP address to the Switch’s System IP interface.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure the IP interface System:
DGS-3024:4#config ipif System ipaddress 10.48.74.122/8
Command: config ipif System ipaddress 10.48.74.122/8
Success.
DGS-3024:4#
99
