DGS-3024 Layer 2 Switch CLI Reference Manual
8
D
OWNLOAD
/U
PLOAD
C
OMMANDS
The download/upload commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
download
[firmware <ipaddr> <path_filename 64> | configuration <ipaddr>
<path_filename 64> {increment}]
upload
[configuration | log] <ipaddr> <path_filename 64>
Each command is listed, in detail, in the following sections.
download
Purpose
Used to download and install new firmware or a switch configuration
file from a TFTP server.
Syntax
download [firmware <ipaddr> <path_filename 64> |
configuration <ipaddr> <path_filename 64> {increment}]
Description
This command is used to download a new firmware or a switch
configuration file from a TFTP server.
Parameters
firmware
−
Download and install new firmware on the Switch from a
TFTP server.
configuration
−
Download a switch configuration file from a TFTP
server.
<ipaddr>
−
The IP address of the TFTP server.
<path_filename>
−
The DOS path and filename of the firmware or
switch configuration file on the TFTP server. For example,
C:\3024.had.
increment
−
Allows the download of a partial switch configuration file.
This allows a file to be downloaded that will change only the Switch
parameters explicitly stated in the configuration file. All other switch
parameters will remain unchanged.
Restrictions
The TFTP server must be on the same IP subnet as the Switch.
Only administrator-level users can issue this command.
Example usage:
To download a firmware file:
DGS-3024:4#download firmware 10.48.74.121 c:\dgs-3024 b08.had
Command: download firmware 10.48.74.121 c:\dgs-3024 b08.had
Connecting to server................... Done.
Download firmware...........……… Done. Do not power off!
Please wait, programming flash…….. Done.
Saving current settings to NV-RAM……Done.
Please wait, the switch is rebooting….
51
