DGS-3024 Layer 2 Switch CLI Reference Manual
22
ARP C
OMMANDS
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
create arpentry
<ipaddr> <macaddr>
config arpentry
<ipaddr> <macaddr>
delete arpentry
[<ipaddr> | all]
show arpentry
{ipif <ipif_name 12> | ipaddress <ipaddr> | static}
config arp_aging time
<value 0-65535>
clear arptable
Each command is listed, in detail, in the following sections.
create arpentry
Purpose
Used to make a static entry into the ARP table.
Syntax
create arpentry <ipaddr> <macaddr>
This command is used to enter an IP address and the
corresponding MAC address into the Switch’s ARP table.
Parameters
<ipaddr>
−
The IP address of the end node or station.
<macaddr>
−
The MAC address corresponding to the IP address
above.
Restrictions Only
administrator-level users can issue this command.
Description
Example Usage:
To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
DGS-3024:4#create arpentry 10.48.74.121 00-50-BA-00-07-36
Command: create arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
DGS-3024:4#
config arpentry
Purpose
Used to configure a static entry in the ARP table.
config arpentry <ipaddr> <macaddr>
Description
This command is used to configure a static entry in the ARP Table.
The user may specify the IP address and the corresponding MAC
address of an entry in the Switch’s ARP table.
Syntax
128
