DGS-3024 Layer 2 Switch CLI Reference Manual
show 802.1x
auth_configuration
authentication process. Authorized means that the user was authenticated,
and can access the network. Unauthorized means that the user was not
authenticated, and can not access the network.
PAE State: Initialize/Disconnected/Connecting/
Authenticating/Authenticated/Held /ForceAuth/ForceUnauth
−
Shows the
current state of the Authenticator PAE.
Backend State: Request/Response/Fail/Idle/Initialize
−
Shows the current
state of the Backend Authenticator.
AdminCtlDir: Both/In
−
Shows whether a controlled Port that is unauthorized
will exert control over communication in both receiving and transmitting
directions, or just the receiving direction.
OpenCtlDir: Both/In
−
Shows whether a controlled Port that is unauthorized
will exert control over communication in both receiving and transmitting
directions, or just the receiving direction.
Port Control: ForceAuth/ForceUnauth/Auto
−
Shows the administrative
control over the port’s authorization status. ForceAuth forces the
Authenticator of the port to become Authorized. ForceUnauth forces the
port to become Unauthorized.
QuietPeriod
−
Shows the time interval between authentication failure and
the start of a new authentication attempt.
TxPeriod
−
Shows the time to wait for a response from a supplicant (user)
to send EAP Request/Identity packets.
SuppTimeout
−
Shows the time to wait for a response from a supplicant
(user) for all EAP packets, except for the Request/Identity packets.
ServerTimeout
−
Shows the length of time to wait for a response from a
RADIUS server.
MaxReq
−
Shows the maximum number of times to retry sending packets to
the supplicant.
ReAuthPeriod
−
Shows the time interval between successive re-
authentications.
ReAuthenticate: Enabled/Disabled
−
Shows whether or not to re-
authenticate.
Parameters
ports <portlist>
−
Specifies a port or range of ports to be viewed.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To display the 802.1x configurations:
DGS-3024:4#show 802.1x auth_configuration ports 1
Command: show 802.1x auth_configuration ports 1
802.1X : Enabled
Authentication Mode : Port_based
Authentication Protocol : Radius_Eap
Port number : 1
Capability : None
AdminCrlDir : Both
111
