DAP-300P
Wireless N300 PoE Access Point / Router
User Manual
Configuring via Web-based Interface
4. Click the
APPLY
button. The
System date
and
System time
fields will be filled in
automatically.
To enable the access point to automatically adjust to daylight saving time, move the
Daylight
saving time
switch to the right. From the
Daylight saving time zone
drop-down list, select the
time zone that will be used during summer time and specify the needed values in the
Beginning of
daylight saving time
and
End of daylight saving time
sections. Click the
APPLY
button.
In some cases NTP servers addresses are provided by your ISP. In this case, you need to move the
Get NTP server addresses using DHCP
switch to the right and click the
APPLY
button.
Contact your ISP to clarify if this setting needs to be enabled. If the
Get NTP server addresses
using DHCP
switch is moved to the right, the
NTP Servers
section is not displayed.
To allow connected devices to use the IP address of the access point in the local subnet as a time
server, move the
Run as a server for the local network
switch to the right and click the
APPLY
button.
!
When the
access point
is powered off or rebooted, the system time is reset to the default
value. If you have set automatic synchronization for the system time, the internal clock of
the device will be configured after connecting to the Inter
net. If you have set the system
time manually, you need to set the time and date again (see above).
Page
166
of 175
