11
with male duplex LC connector type for one side. To connect to 1000Base-LX transfer, use
the single-mode fiber cable with male duplex LC connector type for one side.
LAN 10/100/1000Base-TX RJ-45 Ports
4x10/100/1000Base-T 8-pin RJ-45 ports are located at the front panel of the Residential
Gateway. These RJ-45 ports allow user to connect their traditional copper based
Ethernet/Fast Ethernet devices into network. All these ports support auto-negotiation and
MDI/MDIX auto-crossover, i.e. either crossover or straight through CAT-5 cable may be
used.
Since there is no separated RJ-45 Management Console port for this Residential Gateway,
however any of these four 10/100/1000Base-T RJ-45 ports can be used temporarily as the
RJ-45 Management Console Port for local management. This temporary RJ-45
Management Console Port of the Residential Gateway and a RJ-45 LAN cable for PC
connections are required to connect the Residential Gateway and a PC. Through these, the
user then can configure and check the Residential Gateway even when the network is
down.
FXS RJ-11 Telephony ports
There are two FXS RJ-11 telephony ports at the front panel of the Residential Gateway.
The
“Phone” ports are for users to connect their traditional telephones.
1.4 Connecting the Residential Gateway
Before starting to configure the Residential Gateway, you have to connect your devices correctly.
When you connect your device correctly, the corresponding LEDs will light up.
Connect the power adaptor to the power port of the Residential Gateway on the back, and
the other end into a wall outlet. The Power LED should be ON.
The system starts to initiate. After completing the system test, the Status LED will light up.
CAUTION:
For the first-time configuration, connect one end of an Ethernet patch cable (RJ-
45) to any ports on the front panel and connect the other end of the patch cable (RJ-45) to
the Ethernet port on Administrator computer. LAN LED for the corresponding port will light
up.
Connect one end of an Ethernet patch cable (RJ-45) to other LAN ports of the Router and
connect the other end of the patch cable (RJ-45) to the Ethernet port on other computers or
Ethernet devices to form a small area network. The LAN LED for that port on the front panel
will light up.
Connect the Fiber cable provided from your service provider to the WAN Fiber port on the
back panel, the WAN LED will light up and blinking if data are transmitting.