Covidien WarmTouch, Service Manual

Page: 184 / 314

Internal Component Replacement (Inside Rear Enclosure)
11-8 Service Manual
10.
Position the thermistor cable against the tie mount on the enclosure as shown in
Figure 11-2 on page 11-4. Secure the cable with a cable tie and trim the end of
the cable tie.
11.
Connect the thermistor cable to the 2-pin connector at P108 on the Power PCBA
(
Figure 11-3 on page 11-5). Make sure that the connector latch engages.
12.
Place a cable tie around the thermistor cable and fan cable approximately 10 cm
(4 inches) from the Power PCBA connectors (
Figure 11-3 on page 11-5). Trim the
end of the cable tie.
13.
Follow the procedure Rejoining the Front and Rear Enclosures on page 9-5.
14.
Perform the following tests:
a.
Power-On Test on page 7-3.
b.
Temperature Accuracy Test on page 7-8.
c.
Electrical Safety Tests on page 7-14.