Scanner Operation - Panel and Indicators
4-5
Power LED Green (startup – phase 2)
Towards the end of Init Sequence, the Power LED will change to
green while the other LEDs remain unchanged (lighted).
From here the scanner moves on to Self Adjustment (startup
phase 3).
Power ON
Power OFF
Wake-up / Sleep - Turn power ON/OFF with power key –normal
use (with outlet switch always ON)
With the outlet switch always ON, use the Operator’s panel Power key
to control scanner power. Hold down on the Power key to toggle
power into Wakeup and Sleep modes.
The Power LED lights green when the scanner is ON (Wake-up) and
red when power is OFF (Sleep). When you turn the scanner ON in
this manner, it starts in Self-Adjustment mode (startup phase 3) as
described below.
When in the power Wake-up/Sleep mode, the scanner can
automatically be powered up and down (wake-up/sleep) by
WIDEsystem’s timer or an idle time setting. See WIDEsystem Help for
instructions.
Self-Adjustment (startup –phase 3)
If you used Hard Power On
- On completion of the Init Sequence,
the power LED (green) and the Wait LED (yellow) remain lighted while
the others LEDs turn off. This indicates that the scanner is running its
Self-Adjustment of light profiles, stitching and black/white points.
If you used Wake-up
- the power LED turns to green and the Wait
LED turns on yellow while others LEDs are off. This indicates that the
scanner is running its Self-Adjustment with warm-up and adjustment
of light profiles, stitching and black/white points.
To maintain optimal conditions, the scanner runs new Self-adjustment
procedures periodically during the day (without lighting the wait LED).
If the Wait indicator flashes, the scanner needs to run Self-Adjustment
but cannot (see below).
Summary of Contents for GS67D
Page 3: ......
