Installation
3-12
3.8 Installation Verification
On All Scanners
1. Locate the scanner icon on the Windows System Tray. This is the WIDEsystem
program icon.
2. Double click on the WIDEsystem program icon.
3. The program should detect a
Selected Scanner
in the dialog.
4. If the scanner was not installed correctly, a message will inform you that your scanner
could not be detected. If this is the case turn off power to all connected devices and
repeat the installation steps.
3.9 Preliminary Maintenance
On All Scanners
Once you have setup your scanner and verified your installation, it is important that you run your
first maintenance session before working with the scanner. Shipping and transportation of your
scanner from the factory may have affected the camera positions and therefore it is
recommended to run camera alignment and calibration using the Scanner Maintenace program
wizard. But before you do so, you must thoroughly clean the scanner’s flat topside (where paper
rests during scanning) and the internal scan area (glass plate and rollers).
Follow the instructions described in the section
Regular
Maintenance
in this Operators Guide.
Summary of Contents for GS67D
Page 3: ......
