Comrex BRIC-Link II, Product Manual

Page: 76 / 104

76
CONFIGURING CROSSLOCK VPN SETTINGS FOR HOTSWAP
In the System Se ngs Tab, open the CrossLock VPN op ons and select “Redundant Transmission” (as shown in
Figure 66 ). Change from the default “O ff ” to “On”, and click “Apply Changes”.
Note: Redundant Transmission is normally used to send the en re audio stream over all available networks
simultaneously; however, when used with HotSwap , it simply allows the en re audio stream to be moved as one,
but only when the primary network fails. Be sure to enable a Backup Network fi rst to avoid unintended network
usage.
CONFIGURING CONTACT CLOSURES FOR HOTSWAP
When HotSwap is enabled and the Primary Network fails, BRIC-Link II can send a contact closure signal to
indicate the failed network state. The contact closure will ac vate when the Backup Network is in use, and can be
con
fi gured to ac vate on either the Remote codec, the Local codec, or both.
Open the CrossLock VPN se ngs in the System Se ngs Tab and select “HotSwap CC Indicator” (as shown in Figure
67 ). Choose the intended contact closure port to ac vate during a network failure, and click “Apply Changes”.