Removal and Replacement Procedures
3-29
Compaq Confidential – Need to Know Required
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
3.
Press outward on both latches of the RIMM at the same time
1
. This
releases the module and pushes it partially out of the socket.
4.
Lift the module from the socket
2
.
2
1
1
Figure 3-24. Removing a RIMM memory module
NOTE:
The system recognizes memory upgrades and automatically reconfigures the
workstation.
Removing a Processor
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
To remove the processor:
1.
Perform the steps in the “Service Preparations” section.
CAUTION:
Before removing the side access panel, ensure that the workstation
is turned off, all cables are disconnected from the back of the workstation, and
the power cord is disconnected from the grounded AC outlet.
2.
Remove the side access panel.
3.
Remove the AGP graphics controller before removing the processor.
