3-40
Compaq Deskpro Workstation AP250 Maintenance and Service Guide
Compaq Confidential – Need to Know Required
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
To replace the lithium battery:
1.
Perform the steps in the “Service Preparations” section.
CAUTION:
Before removing the side access panel, ensure that the workstation
is turned off, all cables are disconnected from the back of the workstation, and
the power cord is disconnected from the grounded AC outlet.
2.
Remove the side access panel.
3.
Locate the battery on the system board.
NOTE:
If expansion boards are installed, you may need to remove the expansion boards
to gain access to the battery.
Figure 3-34. Locating the battery on the system board
