Removal and Replacement Procedures
3-13
Compaq Confidential – Need to Know Required
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
To remove a 3.5-inch drive with a 5.25-inch drive adapter:
1.
Perform the steps in the “Service Preparations” section.
CAUTION:
Before removing the side access panel, ensure that the workstation
is turned off, all cables are disconnected from the back of the workstation, and
the power cord is disconnected from the grounded AC outlet.
2.
Remove the side access panel.
3.
Remove the front bezel.
4.
Disconnect the cables from the back of the drive.
5.
Slide the drivelock to unlock the drive.
Figure 3-11. Releasing the hard drive with the drivelock
NOTE:
Do not hold the face plate while removing a drive. Only hold a drive by its casing.
6.
While sliding the drivelock, push from the rear of the drive until the
drive casing can be grasped from the front.
