Removal and Replacement Procedures
3-33
Compaq Confidential – Need to Know Required
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
4.
Using a Torx T-15 screwdriver, loosen the four claynuts
1
that attach
the processor guide rails to the system board, then remove the rails
2
.
2
1
Figure 3-28. Removing the processor guide rails from the system board
To replace the processor guide rails, seat the guide rails flush with the system
board, then tighten the four claynuts.
Removing the Speaker
To remove the speaker:
1.
Perform the steps in the “Service Preparations” section.
CAUTION:
Before removing the side access panel, ensure that the workstation
is turned off, all cables are disconnected from the back of the workstation, and
the power cord is disconnected from the grounded AC outlet.
2.
Remove the side access panel.
3.
Disconnect the speaker cable from the system speaker connector on the
system board.
