Removal and Replacement Procedures
3-25
Compaq Confidential – Need to Know Required
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
Removing an Expansion Board
To remove an expansion board:
1.
Perform the steps in the “Service Preparations” section.
CAUTION:
Before removing the side access panel, ensure that the workstation
is turned off, all cables are disconnected from the back of the workstation, and
the power cord is disconnected from the grounded AC outlet.
2.
Remove the side access panel.
3.
Disconnect any cables from the expansion board.
4.
Remove the expansion board retaining screw.
5.
Hold the expansion board at each end and carefully pull out until the
connectors pull free from the slot.
Figure 3-21. Removing an expansion board
To install an expansion board, remove the expansion slot cover and reverse the
above procedure.
