4-22
Compaq Deskpro Workstation AP250 Maintenance and Service Guide
Compaq Confidential – Need to Know Required
Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: e-ch4 Diagnostic Tools.doc Last Saved On: 10/26/99 3:09 PM
Table 4-11
Network Problems
continued
Problem
Cause
Solution
Diagnostics reports a
failure.
1.
The cable is not securely
connected.
2.
The cable is attached to the
incorrect connector.
3.
There is a problem with the
cable or a device at the
other end of the cable.
4.
The network controller is
defective.
5.
Network controller
interrupts or memory
overlaps the interrupt or the
memory of an expansion
board.
1.
Be sure the cable is
securely attached to
the network
connector and that
the other end of the
cable is securely
attached to the
correct device.
2.
Be sure that the cable
is attached to the
correct connector.
3.
Be sure that the cable
and device at the
other end are
operating correctly.
4.
Replace the controller
or the system board.
5.
Run Computer Setup
and modify the
network controller
memory value.
Diagnostics passes,
but the system does
not communicate
with the network.
1.
Network drivers are not
loaded, or driver parameters
do not match current
configuration.
2.
The network controller is
not configured for the
workstation.
3.
The network controller
interrupt or memory
overlaps the interrupt or
memory of an expansion
board.
1.
Be sure the network
drivers are loaded
and that the driver
parameters match the
configuration of the
network controller.
2.
Select the Network
icon in the Control
Panel.
Reconfigure the driver
if necessary, using
the Network Setup
found in the Control
Center.
3.
Run Computer Setup
and modify the
network controller
memory value.
continued
